Skip to main content
Inspection outcome
Opened: February 5, 2019 · Closed: March 27, 2019
Citations issued

OSHA issued one or more Other-than-serious citations.

Safety inspection · Planned (Programmed) · Partial — limited to specific operations or areas

Violations2
Serious+0
Initial penalty$23,868
Current penalty$11,934
Accidents0
Duration50d
Summary

What happened in this inspection

On February 5, 2019, OSHA opened Williams Form Engineering Corp’s inspection #343762225 at GOLDEN, Colorado. The case was administratively closed on March 27, 2019, 50 days after opening.

OSHA cited the employer for 2 violations totaling $11,934 in current penalties — reduced from an initial proposed total of $23,868. All citations were Other-than-serious.

Breakdown by classification
2violations total
Repeat150%

A Repeat violation means OSHA cited the employer for a substantially similar violation within the past 5 years. Penalties multiply (up to ~$165,000 per repeat citation) and indicate the employer failed to permanently abate a recurring hazard.

Other-than-serious150%

An Other-than-serious violation has a direct relationship to job safety and health but probably would not cause death or serious physical harm. Maximum penalty is ~$16,550 per violation. Often involves recordkeeping or procedural lapses.

Citations

Citations issued in this inspection

2citations issued
$11,934current penalty
↓ $11,934total reduction
Look up on OSHA.gov
Repeatgravity 10
Citation #01001
29 CFR 1910.184(i)(9)(iv)View full regulation text on OSHA.gov
Initial$23,868
Current$11,934reduced by $11,934

Standard codes link to the regulation text on OSHA.gov. The text describes the rule itself; the specific findings of this inspection appear above. To see OSHA’s official record of this inspection, search activity number 343762225 at OSHA Establishment Search.

Same employer

Other OSHA inspections at Williams Form Engineering Corp

Earlier or related cases at this establishment.

Full inspection history →
Reference

About OSHA inspections

The U.S. Occupational Safety and Health Administration (OSHA) conducts inspections under several triggers: programmed targeting of high-hazard industries, employee complaints, workplace accidents, fatalities, and follow-ups to prior citations.

📋
Citations

Each citation specifies a section of 29 CFR, a severity tier, and a proposed penalty. Employers can contest citations through OSHA’s informal conference or before the OSH Review Commission.

Open vs closed

An open case has not yet been administratively closed — citations may follow or the case may close without action.

💰
Current vs initial penalty

Initial penalty is the proposed amount at citation. Current penalty is the post-conference / settlement figure on file today.

🔗
Trigger types

A = Accident, B = Complaint, H = Programmed, F = Follow-up. See the glossary for all codes.

About this inspection

OSHA classified this as Planned (Programmed) — a programmed (planned) inspection, typically targeting high-hazard industries.

Sources

Cross-check with OSHA directly

This page draws from the OSHA Integrated Management Information System (IMIS) via the DOL Open Data Portal. For the authoritative record, look up activity number 343762225 directly: